Golden Designs Reserve 4-Person Full Spectrum Sauna
Need help before ordering?
Book a quick video consult and ask us about power, placement, EMF, delivery, or assembly.
Book a video meetingPrefer email? Contact info@saunass.com
Specifications 58" W x 54.5" D x 74" H · 3 person · Canadian Hemlock
This Reserve 3 Person is a freestanding full spectrum infrared cabin where 6 of the 9 heaters are Near Zero EMF carbon panels, with three Himalayan salt bars, running on a dedicated 120V / 20A circuit.
Power: This Reserve model runs on a single dedicated 120V / 20A non-GFCI circuit, not 240V. A certified electrician should install the outlet and breaker.
Heat: Full spectrum infrared warms the body directly rather than the air, so it runs cooler than a traditional sauna. Ideal range is 118°F to 132°F, with a 140°F maximum.
What's in the Box & Setup Complete cabin · dedicated 20A circuit
Everything that comes with your Reserve 3 Person and the main setup notes to review before delivery.
In the box
- Pre-built Canadian Hemlock wall, roof, floor, and bench panels
- 6 PureTech Near Zero EMF carbon panels and 3 near infrared emitters, pre-installed
- 3 Himalayan salt bars (2 above the heaters, 1 below the bench)
- Bronze privacy tempered glass door with black handle and interior towel bar
- Interior LED control panel
- Oversize chromotherapy lighting, plus exterior accent lighting
- Bluetooth and MP3 aux sound system with built-in speakers
- Assembly hardware and illustrated instructions
What you provide
This Reserve 3 Person is a complete, self-contained cabin. You will need a dedicated 120V / 20A outlet and a spot to put it.
- A dedicated 120V / 20A outlet within reach (installed by an electrician)
- A level indoor floor surface
Setup notes
- One dedicated 120V / 20A circuit Runs on a single 120V / 20A non-GFCI dedicated circuit, not 240V. A certified electrician should install the outlet and breaker before delivery.
- Assembly with two adults Cabin panels connect with built-in buckle clasps; the 5 cartons assemble with two adults over an afternoon.
- Indoor use only Place on carpet or any indoor floor, with a few inches of clearance around the cabin for airflow.
- Break-in cycle Run one short empty heat cycle before your first session to clear any manufacturing residue.
Recommended for assembly
Most panels connect by built-in buckle clasps, so assembly is largely tool-free.
- Phillips screwdriver
- A second person
- Step stool (optional)
Setup questions? Email info@saunass.com

